The reconstitution ratio is one division
A reconstitution ratio is the relationship between how much peptide is in a vial (in mg) and how much bacteriostatic water is added (in mL), expressed as a concentration in mg/mL. The formula is: mg in the vial ÷ mL of water = mg/mL. Every other reconstitution calculation builds on this single division.
Why the same vial can be reconstituted differently
There’s no single “correct” ratio for a given vial size. A 10mg vial can be reconstituted with 1mL (10mg/mL), 2mL (5mg/mL), or 4mL (2.5mg/mL), and each is a valid choice. What differs is how many units a given mg dose works out to on a syringe afterwards.
Comparing retatrutide and tirzepatide vial ranges
Retatrutide is commonly sold in the UK in 2mg, 5mg, 10mg, and 20mg vials. Tirzepatide is commonly sold from 5mg up to 40mg or more. Because tirzepatide is available in a wider range of sizes, buyers often have more flexibility in landing on a preferred concentration without needing an unusual water volume.
A worked example for each
A 10mg retatrutide vial with 2mL water gives 5mg/mL; a 2.5mg amount is then 2.5 ÷ 5 × 100 = 50 units. A 20mg tirzepatide vial with 2mL water gives 10mg/mL; a 5mg amount is then 5 ÷ 10 × 100 = 50 units. Different vial sizes and mg amounts can land on the same unit figure once the ratio is chosen deliberately.
What to check before buying, to make sure your ratio works
Confirm the vial’s total mg via its label and a certificate of analysis. Confirm your mixing syringe has enough capacity for your intended water volume (a 3mL or 5mL syringe covers most common ratios). Confirm your dosing syringe’s unit range comfortably covers the unit figures your ratio will produce for typical amounts.
Why buying from a seller who states their own suggested ratio helps
A stated ratio on the listing, such as those shown alongside COA data on Enzo Meds’ retatrutide and tirzepatide pages, gives a reference point to check your own calculation against, and confirms the seller’s own numbers are internally consistent (mg ÷ mL matching their stated mg/mL).
Choosing a ratio that suits your syringes
A ratio that produces round unit numbers, 25, 50, 75, 100, for your typical amounts is easier to measure precisely and easier to double-check at a glance than one producing numbers with repeating decimals. Adjusting the water volume slightly, rather than the vial size, is usually the simplest way to land on rounder numbers.
A quick checklist
Vial’s total mg confirmed via label and COA before calculating anything. Water volume chosen deliberately, not just at a seller’s default suggestion. Mixing and dosing syringe capacities checked against the resulting numbers. Ratio recalculated and double-checked with the same division each time it’s used.